Page 1 of 1

Trail Cross Reference

Posted: Thu Apr 30, 2015 9:27 pm
by Weasel
Cross Reference to local trail names and Forest Service trail numbers. Please be respectful of the trails.

Trail Cross Reference

Posted: Sun Oct 11, 2015 12:12 pm
by EYunag
Thank you!

Trail Cross Reference

Posted: Thu Jun 09, 2016 11:50 am
by CHIEFWAHO
Planning a wheeling trip later this June. Been using this cross reference and the Forest Service maps to get familiar with trail locations, ratings and names.

I can't seem to find names for the 2 trails (8144 & 8271) up by Piedmont.

What are their names and rating? Thanks in-advance!

http://www.fs.usda.gov/Internet/FSE_DOC ... 341610.pdf

Re: Trail Cross Reference

Posted: Fri Jun 10, 2016 10:12 pm
by twfuller
8144 is the Piedmont Fire Trail and 8271 doesn't have a name that I know of. Both are rated Subaru Forester. You will meet a lot of ATV's on both so be careful.

Re: Trail Cross Reference

Posted: Mon Jun 13, 2016 12:17 pm
by axleater
confirmed on the subaru, that is the road we take with michelles forester to go to Nemo for dinner!

Trail Cross Reference

Posted: Mon Jun 13, 2016 12:32 pm
by CHIEFWAHO
So I guess, tons and 43 stickies not required for this one. Thanks!

Re: Trail Cross Reference

Posted: Sat Jun 10, 2017 3:59 pm
by twfuller
Your stock toy truck can handle the 3 trails with some care. An experienced spotter could get you through the 4s and 5s but rocker panel protection and a skid plate wold be good insurance. I wouldn't try any of the trails in your rig by yourself. two vehicles are way better than one when it comes to getting out of a jam.

You should have come along on the intro to BH 4 wheeling run last Sat. We had a good time.

Re: Trail Cross Reference

Posted: Mon Jun 12, 2017 8:35 am
by axleater
for sure a good idea to come out and see some trails to get a better idea. a stockish vehicle with good skid plates, rockers, and bumpers can make its way through trails that a seemingly better build vehicle cannot. Some trails are pretty tight and may not be technically difficult but would be hard to get a lot of sheet metal through without damage.